Minolta Magicolor 3100 Series - Manual (Page 50)

1-50
FIP-12 Regi Jam (Media Jam Registration)
Step Check
Yes No
1
Initial check
Check the following for damage.
SENSOR REGI actuator condition
CHUTE ASSY REGI condition
Replace the parts
concerned
With tool
Go to step [2]
Without tool
Go to step [3]
2
Check SENSOR REGI
Does SENSOR REGI function normally?
Using SENSOR REGI diagnostic tool, check by Diagnostic
Input Test.
Go to step [6] Go to step [3]
3
Check REGI CLUTCH HARNESS for connection
Is it connected normally to the SENSOR REGI?
Go to step [4]
Replace the parts
concerned
4
Check REGI CLUTCH HARNESS for continuity
J181 <=> J18 check continuous?
Go to step [5]
Replace CHUTE
REGI
5
Check PWBA HNB MCU for signal
Is P/J18-3 <=> P/J18-2 0VDC?
With tool
Go to step [6]
Without tool
Go to step [7]
Replace SENSOR
REGI
6
Check CLUTCH REGI
Does the CLUTCH REGI function normally?
Using CLUTCH REGI diagnostic tool, check by Diagnostic
Output Test.
In the test, close the INTERLOCK SW.
Go to step [9] Go to step [7]
7
Check CLUTCH REGI for resistance value
Remove the CLUTCH connector J18.
Is J18-4PIN <=> J18-5PIN less than 200
Ω?
Go to step [8]
Replace CHUTE
REGI
8
Check PWBA HNB MCU for signal
Close the INTERLOCK SW
Is P18-4PIN <=> P18-2PIN +24VDC?
Go to step [9]
Replace PWBA
HNB MCU
9
Check CHUTE REGI
Does the ROLL rotate smoothly by hand?
Replace the
CHUTE REGI on
the machine, and
check the gears
for meshing.
Replace CHUTE
REGI