Minolta Magicolor 3100 Series - Manual (Page 229)

Chapter 3 Removal and Replacement Procedures
3-227
Removal
1) Release the latch at A from the printer and open the FRONT ASSY IN (PL5.1.1).
1) Remove the PHD.
2) Release the hooks at 2 positions securing the HOUSING ASSY ELEC (PL9.1.11) to the printer and
remove the HOUSING ASSY ELEC upward.
3) Remove the connector (P/J18) of the CHUTE ASSY REGI from the printer.
Remove the connector (P/J32) of the OHP SENSOR, if installed.
4) Remove 4 screws securing the CHUTE ASSY REGI to the printer.
5) Raise the left end of the CHUTE ASSY REGI and pull out the CHUTE ASSY REGI leftward from the
printer.
Replacement
Replace the components in the reverse order of removal.