Minolta Magicolor 3100 Series - Manual (Page 408)

8-408
Recording system: Operating status
Fuser fan: Operating at high speed
Rear fan: Operating at high speed
◆ Ready mode
Ready state
Fixing system: Stop status *1
Exposure system: Stop status *2
Recording system: Stop status
Fuser fan: Stop status *3 (half-speed running)
Rear fan: Stop status *3 (half-speed running)
*1: Can be changed ready temperature status from the controller.
*2: Can be changed operation status from the controller.
*3: Fan status is changed depending on the state (temperature, etc.) of the fixing system.
4.7 Speed Mode
Speed mode of the printer san be switched over between full-speed mode (printing at the highest
processing speed of the printer) and half-speed mode (printing at the half-speed processing mode). The
controller cannot instruct to change the speed mode.
4.8 Print Mode
Standard mode, fine mode and high gross mode are available for the printer. Mode is switched by the
instruction from the controller. The high gross mode can be selected only for the plain paper, 600psi.
4.9 Paper Mode
11 paper modes are available for this printer. Modes are switched over under the instruction from the
controller.
Classification of paper mode
(1) Plain paper L mode
(2) Plain paper H mode
(3) Woodfree paper L mode
(4) Woodfree paper H mode
(5) Thick paper L mode
(6) Thick paper H mode
(7) Label L mode
(8) Label H mode
(9) OHP mode
(10) Envelope mode
(11) Postcard mode
Relation between the resolution, speed mode, print mode and paper mode is shown in the table below.