Minolta Magicolor 3100 Series - Manual (Page 263)

Chapter 3 Removal and Replacement Procedures
3-261
Removal
1) Remove the FUSER ASSY. (RRP8.1)
2) Remove the CHUTE ASSY REGI. (RRP9.3)
3) Remove the COVER TOP MAIN. (RRP1.4)
4) Remove the COVER ASSY FRONT HEAD. (RRP1.2)
5) Remove the COVER MSI. (RRP1.11)
6) Remove the TRAY ASSY MSI. (RRP1.12)
7) Remove the COVER ASSY FRONT. (RRP1.13)
8) Remove the COVER ASSY FRONT IN. (RRP1.10)
9) Remove the COVER SIDE L. (RRP1.14)
10) Remove the HSG ASSY BIAS. (RRP9.2)
11) Remove the COVER SIDE R. (RRP1.9)
12) Remove the COVER ASSY TOP PHD. (RRP1.5)
13) Remove the COVER REAR. (RRP1.6)
14) Remove the HOLDER TCRU ASSY UNIT. (RRP10.1)
15) Remove the PWBA HNB DRV. (RRP12.6)
16) Remove the CLAMP GUIDE HARNESS (PL12.1.3) at 2 positions secured on the GUIDE HARNESS
SW of the LVPS STD.
17) Shift the harness from the GUIDE HARNESS SW.
18) Release the hooks at 2 positions securing the GUIDE HARNESS SW to the switch bracket on the
LVPS STD.
19) Remove the GUIDE HARNESS ASSY from the LVPS STD.
20) Remove the HARNESS ASSY AC SW. (RRP12.5)
21) Remove the connector (P/J162), (P/J163), (P/J164), (P/J165) and (P/J167) on the LVPS STD.
22) Remove 3 screws securing the LVPS STD to the printer.
23) Remove the LVPS STD from the printer.
Replacement
Replace the components in the reverse order of removal.