Grain Systems PNEG-707GSI - Manual (Page 127)

10. Catwalks and Platforms
PNEG-707 12', 18', 24' and 30' GSI Commercial Tower Dryer 127
Outside Catwalk (Continued)
1. Snug bolt outside catwalk diagonal support to outside catwalk support clips around perimeter of dryer.
Two (2) catwalk support clips were installed on each vertical channel as wall sheets were installed.
2. Pre-assemble outside catwalk door (see Figure 10T) as follows. (Double nut at X for movement
of parts.)
Bolt A at “X
1
” to outside catwalk outside door toeboard. Bolt A at “X
2
” to B.
Center assembled outside catwalk door between and just below ladder rung. Install.
Figure 10T “X” Marks hinge points for outside catwalk door.
3. (On ground) assemble remaining catwalk flooring from outside catwalk section and outside
catwalk toeboards.
4. Snug bolt outside catwalk vertical supports to outside catwalk floor supports.
5. Snug bolt upper and lower outside catwalk handrails to catwalk vertical supports.
6. Bolt Outside Catwalk section and lay middle and inside on catwalk and place after above jacks.
7. Check uprights are plumb to the eye. Tighten bolts.
8. Lift dryer.
9. When catwalk is clear of jacks, place remaining catwalk flooring and bolt tight.
NOTE: If required, install second outside catwalks using the same steps.
A
X 1
B
X 2