Grain Systems PNEG-707GSI - Manual (Page 200)

18. Windows and Doors
200 PNEG-707 12', 18', 24' and 30' GSI Commercial Tower Dryer
Heat Section Door (Continued)
Screw two (2) door latches in pre-drilled holes on outside of heat section door.
Screw two (2) hooking brackets to door frame. Position to keep heat section door tightly shut.
Check fit of heat section door in door frame, and adjust as required.
Figure 18AQ Close Up - Installing heat section
door sleeve.
Figure 18AR Tap hammering heat section door sleeve
around inside of door frame.
Figure 18AS Pressing bulb seal around inside edge
of heat section door sleeve.