Grain Systems PNEG-707GSI - Manual (Page 197)

18. Windows and Doors
PNEG-707 12', 18', 24' and 30' GSI Commercial Tower Dryer 197
Cool Section Door
See Orientation Section on Page 32 for flat layout, for cool section door placement in the dryer model.
Cool section door should allow comfortable step-in access to cool section.
Check that cool section door is level and square to dryer.
NOTE: Caulking and bulb strip are not required.
1. Pre-assemble 24" window kit as in section Pre-assembly of Window Kits on Page 189 . This is the
cool section door frame.
2. Install cool section door frame to dryer as in section Installation of Window Kits (18" and 24") on
Page 191 .
3. Install louvered assembly to cool section door frame as follows.
Use 5/16" x 3/4" bolts and nuts.
With common bolts, install latch/hinge bracket to both L.H. and R.H. sides of window frame, bolting
through outside wall sheets.
(See Figure 18AG on Page 196.)
Bolt louvered assembly to tabs on latch/hinge bracket on one side. Pin closed.
Figure 18AK Cool section door is installed.