Anchoring dryer legs – Grain Systems PNEG-707GSI User Manual
Page 215
19. Tower Base
PNEG-707 12', 18', 24' and 30' GSI Commercial Tower Dryer
215
Anchoring Dryer Legs
When dryer is round and vertical, anchor lower legs to dryer foundation as follows.
Use supplied HILTI HAS anchor bolts.
IMPORTANT: Drill out bolt holes in base of lower leg. See manufacturer’s instruction sheet for proper
size hole to securely anchor dryer.
Install bolts to bolt holes at base of lower leg with ceramic epoxy.
IMPORTANT: Apply ceramic epoxy and set anchor bolts according to manufacturer’s instructions. See
manufacturer’s MSDS (Material Safety Data Sheet) for safety hazards and precautions.
Figure 19AA Hammer Drill and Bit
Figure 19AB Ceramic Epoxy Injection Tool
Figure 19AC Ceramic Epoxy Injection Tool Cartridge
Figure 19AD Ceramic Epoxy Injection Tool Nozzle