Grain Systems PNEG-707GSI - Manual (Page 196)

18. Windows and Doors
196 PNEG-707 12', 18', 24' and 30' GSI Commercial Tower Dryer
Louvered Windows
See Orientation Section on Page 32 for flat layout for window placement in the dryer model.
Check that 24" louvered windows are level and square to dryer.
1. Pre-assemble 24" window kit as in section Pre-assembly of Window Kits on Page 189 . This is the
window frame.
2. Install window frame to dryer as in section Installation of Window Kits (18" and 24") on Page 191 .
3. Install louvered assembly to window frame as follows.
Use 5/16" x 3/4" whiz lock bolts and nuts.
With common bolts, install latch/hinge bracket to both L.H. and R.H. sides of window frame, bolting
through outside wall sheets.
(See Figure 18AG.)
Bolt louvered assembly to tabs on latch/hinge bracket on one side.
Figure 18AG Use common bolts on latch/hinge
bracket, window frame, and outside wall sheets
(arrow). Insert bolts toward inside of dryer.
Figure 18AH Installed 24" louvered window, with
louvers closed.
Figure 18AI Installed 24" louvered window, with
louvers open.
Figure 18AJ Outsided View - Installed 24" louvered
window, with louvers open.