Grain Systems PNEG-707GSI - Manual (Page 198)

18. Windows and Doors
198 PNEG-707 12', 18', 24' and 30' GSI Commercial Tower Dryer
Heat Section Door
See Orientation Section on Page 32 for flat layout, for heat section door placement in the dryer model.
Locate heat section door to right of outside ladder. Center heat section door between two (2)
vertical channels.
Heat section door placement should give comfortable step-in access to reducer walkway.
Check that heat section door is level and square to dryer.
1. Pre-assemble 24" window kit as in section Pre-assembly of Window Kits on Page 189 . This is the
door frame.
2. Install door frame to dryer as in section Installation of Window Kits (18" and 24") on Page 191 .
3. Install heat section door as follows.
NOTE: Flange on heat section door faces to outside of dryer.
Use 5/16" x 3/4" whiz lock bolts and nuts, except where noted.
Bolt hinge-door side to heat section door.
Bolt hinge-frame side to hinge-door side.
Bolt hinge-frame side to door frame.
Figure 18AL
Figure 18AM
Figure 18AN
A. Heat section door (flange faces to outside) (GTI-0257)
B. 3" Wide heat section door sleeve (N/S) (GTI-0258)
A
A B C D E
B
A
A
A. Hinge-door side (D01-0508)
B. Hinge-frame side (GT1-0256)
C. Door latch (GT3-0106)
D. Hooking bracket (GT3-0107)
E. Door handle