Grain Systems PNEG-707GSI - Manual (Page 148)

14. Burner and Reducer
148 PNEG-707 12', 18', 24' and 30' GSI Commercial Tower Dryer
Burner and Burner Housing (Continued)
c. Loosely bolt pairs of burner support tees (back to back) to burner housing. Use 1/2" x 1-1/2"
bolts, nuts. Install washers on outside of burner housing.
Loosely bolt burner support tees to burner support brackets. Use 1/2" x 1" bolts and nuts.
d. Bolt burner support clips (already on burner manifold) to burner support brackets. Use 1/2" x 1"
bolts and nuts.
e. Tighten all bolts.
7. Models 2500/3000/3500:
Bolt burner baffle supports to burner housing. Bolt burner baffles to burner baffle supports. Use
5/16" x 3/4" bolts and nuts.
NOTE: Fuel piping will be installed in later step.
NOTE: After reducer walkway is installed, 44" ladder sections will be installed to outside of burner
housing and reducer.
Figure 14H Moving burner, burner baffles and other
parts inside burner housing.
Figure 14I Bolting together halves of burner housing.
Figure 14J Installing burner housing outlet baffle
to top rim of burner housing.
Figure 14K Close up inside burner housing - Installing
burner housing outlet baffle to top
rim of burner housing.