Grain Systems PNEG-707GSI - Manual (Page 227)

21. Hopper
PNEG-707 12', 18', 24' and 30' GSI Commercial Tower Dryer 227
Hopper (Cross Section) Example - All Models (Continued)
Figure 21W Aligning hopper discharge weldment to
outside hopper panels.
Figure 21X Drilling two (2) outside bolt holes at each
end of metering drum bearing support. NOTE: Center
bolt hole (arrow) is bolted with common bolt to a flat
edged outside hopper panel seam. Check for level.
Figure 21Y Installing metering drum floor clips (arrow)
around bottom perimeter of outside hopper.
Figure 21Z Installing metering drum floor to underside
of metering drum floor clips. Check for level.
Figure 21AA Close Up - Installing metering drum
floor to metering drum floor clips.
Figure 21AB Caulking metering drum floor
with silicone caulk.
Metering drum floor to
be installed to clips.
.
Metering drum