Grain Systems PNEG-707GSI - Manual (Page 435)

PNEG-707 12', 18', 24' and 30' GSI Commercial Tower Dryer 435
27. Appendix A
Tools and Equipment
IMPORTANT: Dryer parts have sharp edges. Use appropriate personal protective equipment.
Use proper lifting technique.
Eight (8) jacks (10000 pound, 14' lift), and lifting tackle.
• Forklift(s), hoist, or tractor with 2" x 14' nylon lifting straps, rating 2000 pounds. (Optional to place
electrical control system).
• Dollies (with 5/8" x 2" heavy structural bolts to secure load). (Motor and blower types.)
• 3/8" and 1/2" Drive impact wrench or rachet, with sockets.
• Drill: 1/2" (1.27 cm), 3/8" (0.9525 cm) Bits, and assorted drill bits.
Hammer Drill: 1/2" (1.27 cm) Masonry bits.
7/8" (2.2225 cm) Masonry bit.
• Wrenches: 1/2" (1.27 cm), 7/16" (1.11125 cm), 9/16" (1.42875 cm), 5/8" (1.5875 cm),
11/16" (1.74625 cm), 3/4" (1.905 cm), 15/16" (2.016125 cm)
Hex wrenches (allen wrenches): 1/8" (0.3175 cm), 5/32" (0.396875), 3/16" (0.47625 cm),
3/8" (0.9525 cm).
• Tongue and groove pliers, locking pliers (vise grips).
• Banding cutters or equivalent equipment.
• Reciprocating saw or hacksaw.
• 3/8" x 12" and larger alignment punches, C-clamps.
• Electrical extension cords, 12 gauge heavy duty, weather-tight.
• Hammers, 10 pound, 2 pound, 13 ounce ball-peen.
• Stepladders (4', 8'), extension ladder.
• 12" level, level-transom, tape measure.
• Heavy-duty pipe sealing compound.
• Marking pen (for steel, concrete).
• Injection silicone caulking, clean-out brush, and air bulb.
• WD40 machine weight lubricating oil.
• Touch-up paint.