Grain Systems PNEG-707GSI - Manual (Page 225)

21. Hopper
PNEG-707 12', 18', 24' and 30' GSI Commercial Tower Dryer 225
Hopper (Cross Section) Example - All Models (Continued)
Figure 21K Metering drum is hoisted before hopper
is installed. NOTE: Access opening in cool
section floor (arrow).
Figure 21L In photo, to demonstrate orientation,
compression angle splice (arrow) is temporary bolted
to compression angles. In actual installation, use
common bolt to install outside hopper panels (over
compression angle splice) to compression angles.
Figure 21M View from above - Bolting outside
hopper panels over compression angles and
compression angle splices.
Figure 21N View from below - Bolting outside hopper
panels over compression angles and
compression angle splices.
Figure 21O Close Up - Aligning outside hopper
panels over compression angles and
compression angle splice (arrow).
Figure 21P Aligning Outside Hopper Panels