Grain Systems PNEG-707GSI - Manual (Page 211)

19. Tower Base
PNEG-707 12', 18', 24' and 30' GSI Commercial Tower Dryer 211
Upper Legs
See Figure 19A on Page 204 and Figure 19B on Page 205 for placement of upper legs. Install upper legs
with support clip side to inside of dryer.
Outside dryer - Bolt upper leg through compression angle weldment to base stiffener weldment.
(See Figure 19S on Page 212.)
Use 5/8" x 2-3/4" grade 8 bolts and nuts.
Inside dryer - Bolt support clip on upper leg to compression angle weldment. (See Figure 19T on Page 212.)
Use 5/8" x 1-1/2" grade 8 bolts and nuts.
Figure 19P
Figure 19Q Aligning upper leg to
base stiffener weldment.
Figure 19R Placing upper leg directly
under base stiffener weldment.
Lower leg
Upper leg