FlexLink XS (45 мм) Монтаж - Manual (Page 15)

Assembly 15
Beam connectors
Introduction
Structural beams can be connected to each other in a
number of ways. Three different methods are described
on the following pages.
Connecting beams using mounting plates
XCFB
Deburr and thread beam ends before assembly. (See
page 8):
Mounting:
1
1
1
1
Countersink
Roller thread fluteless tap M6
Box wrench 10 mm
Allen key 5 mm
Hex socket head screws MF6S 8×30
Hex head screws M6S 8×16
Washers BRB 8,4×16
Slot nuts M8 thread
1 Attach a mounting plate to the beam end using
MF6S 8×30 hex socket head screws and washers.
2 Tighten the screws using an Allen key.
3 Insert slot nuts into the T-slots of the transverse beam.
4 Screw the mounting plate onto the side of the trans-
verse beam using hex head screws M6S 8Ч16.