FlexLink XS (45 мм) Монтаж - Manual (Page 3)

Introduction 3
Tools
General tools
To assemble a FlexLink conveyor, you will need most of
the tools listed on the following pages. Not all are essen-
tial, but they will make your assembly work easier and
more efficicient.
Hand tools
Power tools
FlexLink tools
Rivet crimping pliers
XS (
∅ 3 mm):
3924776
XL/XM/XH (
∅ 4 mm):
3925800
Rivet crimping clamp
XS (
∅ 3 mm):
3924770
XL/XM/XH (
∅ 4 mm):
3923005
The riveting tools have replace-
able pads. By replacing the pads
you can use the same riveting
tool for 3 mm and 4 mm rivets.
Drill fixture for installation of
slide rail
XS (
∅ 3,2 mm):
3924774
XL/XM/XH/XK (
∅ 4,2 mm):
3920500
Mounting tool for slide rail
XS/XL: XLMR 140
XM: XMMR 140
XH: XHMR 200
XK: XKMR 200
Mounting toolkit for guide rail (XK)
3926757
Each kit is delivered with two tools.
Pin insertion tool for chain
XS/XL: XLMJ 4
XM: XMMJ 6
XH: XHMJ 6
XK: XKMJ 8
Guide rail bending machine
3922963 (not shown)
Drill fixture for fastener yokes
XCAD 18
To drill for fastener yokes
(page 17–18), the 10 mm
drill insert has to be
removed. The drill insert is
secured by a locking screw.
With the stop tongue down, the fixture is inserted into
the T-slot of the beam until stop, and then locked. The
hole will be drilled 22 mm from the beam end and cen-
tered by the fixture.
10 and 13 mm box wrench
Cutters (for cutting slide rail)
Set of metric Allen keys
Roller thread fluteless tap and tap wrench (M6 and M8)
Countersink bit
Tape measure
In addition, the tools listed below can be useful:
Files
Socket wrench
Screw-driver
Pliers
Knife (for cutting off plastic screw heads)
Soft faced hammer
Clamp (for chain installation)
Level
Cross-cut circular saw for aluminium
Hand drill
Drill bit (for fixing of slide rail):
XS:
∅3,2 mm, XL/XM/XH/XK: ∅4,2 mm