FlexLink XS (45 мм) Монтаж - Manual (Page 55)

Assembly 55
Conveyor system XK
Installation of slide rail on conveyor beam
XKCB N
Mounting:
Cutting pliers
Hammer
Screwdriver
Clamp
Knife
Drill
Drill bit
∅4,2 mm
Drill fixture 3920500
Plastic screws XWAG 5
1 Cut the slide rail in a 45° angle.
2 Mount slide rail on the lower flange of the conveyor
beam.
3 Drill holes for plastic XWAG 5 screws.
4 Use a screwdriver to insert the screws. Cut off the
screw heads using a knife and a hammer. File off pro-
truding edges.
5 On the upper flange of the slide rail, use the drill fix-
ture to drill two holes in the slide rail before it enters
the XKCB N beam.