FlexLink XS (45 мм) Монтаж - Manual (Page 8)

8 Assembly
Feet (continued)
Deburring and threading beam ends
Before mounting foot plate XCFB 88/44 F, end plate
XCFE and mounting plate XCFB, the holes in the beam
cross-section must be deburred and threaded.
Mounting:
Attaching feet using end plates
XCFE
End plates are used as attachment for adjusting feet and
castors, and are screwed onto the support beam ends
before the actual foot is mounted.
Mounting:
Countersink
Roller thread fluteless tap M6/M8
1 Deburr the holes using a countersink.
2 Thread the holes using a 6 mm or 8 mm roller thread
fluteless tap, depending on beam and component
type.
Countersink
Roller thread fluteless tap M6/M8
Allen key 5 mm
1 Attach the end plate to the beam by inserting four hex
socket head screws into the holes on the end plate.
2 Tighten the screws using an Allen key.