FlexLink XS (45 мм) Монтаж - Manual (Page 32)

32 Assembly
Slide rail and support rail (continued)
Mounting support rail in plain bends
Mounting:
1 Cut the support rail in a 45° angle. The cut should be
made at the leading edge of the rail, in the direction of
travel, to ensure a smooth entrance of the chain.
2 Mount the support rail on the inside of the beam pro-
file. Let the rail run along the entire bend, including the
straight sections of each end.
3 Cut the rail at the other end in a 90° angle using a
knife and a soft hammer.
4 Drill a hole at the first end (in the direction of travel) of
the inner bend using a 4,2 mm drill bit. Leave a dis-
tance of 20 mm between the hole and the beam end.
Deburr the hole.
5 Clamp the support rail to ensure a proper fit. Insert a
short piece of rail between the clamp and the support
rail to get a tight grip. Repeat this procedure along the
entire bend.
6 Insert a plastic XLAG 5 screw in the drilled hole and
tighten it. Make sure that the screw enters the support
rail.