FlexLink XS (45 мм) Монтаж - Manual (Page 35)

Assembly 35
Chain (continued)
Mounting the chain
Make sure that the slip clutch is released allowing the
drive shaft to turn freely. (See previous page.)
Mounting:
Pin insertion tool X..MJ
1 Insert the chain into the underside of the drive unit.
Make sure the chain will be moving in the correct
direction, as indicated by the arrow located at the side
of all chain links.
2 Feed the chain along the conveyor by pulling it
through the idler unit and back to the drive unit.
3 Join 5 meter lengths of chain when necessary.
4 Stretch the chain and remove links if necessary, so
that the chain will exhibit some slack at the drive unit.
(Length adjustment, see page 37)
Connect the chain ends. (See page 33)