FlexLink XS (45 мм) Монтаж - Manual (Page 53)

Assembly 53
Front piece (continued)
Mounting front piece
Mounting:
1 The front piece is fastened to the conveyor by means
of a linkage kit (1) and locking levers (2).
2 Attach the support pairs, two on each side, first to the
front piece and then to the conveyor beam T-slot,
using a 13 mm wrench.
3 Attach bend supports and locking device to the front
piece and conveyor beam. Bend supports are
mounted on one side only.
4 Adjust the height of the front piece using the locking
levers on the bend supports and locking device.