FlexLink XS (45 мм) Монтаж - Manual (Page 4)

4 Introduction
Fasteners
1. Standard screws, nuts, washers
M6S, MC6S, MF6S, M6M, BRB 8,4×16, XLAL
2. Slot nuts and square nuts
XCAN, XLAQ
Square nuts can be used in support beams and small
beams instead of XCAN nuts, but they can also be used
in conveyor beams as opposed to XCAN nuts. They do
not stay in place in vertical positions and have to be
inserted from the beam end.
When using XLAQ square nuts, remember to put in a
sufficient number before completing the assembly.
XCAN
On the support beam, the slot nut can be entered into the
T-slot from the beam side. It will stay in position in vertical
T-slots because of a thin leaf spring.
For small beams (e.g. XCBB ..Ч24Ч44), the nut must
be entered from the beam end because of the design of
those beams.
IMPORTANT
Slot nuts can not be used with conveyor beams. (This
does not apply to the XK conveyor system.)
3. Connecting strips
X..CJ
Connecting strips are used for joining beams together,
end to end. Use Allen key and set screws when attaching
the connecting strip to the beam.
4. T-bolts
XLAT
T-bolts can be entered from the beam side, and when
turned 90
° they will stay in place after tightening with nuts
(XLAN 8) and washers (BRB 8,4×16). The indication
groove in the T-bolt should be at 90° to the conveyor T-
slot.
T-bolts are used when attaching support brackets,
guide rails and drip trays to the conveyor beam. Do not
use T-bolts with support beams!