FlexLink XS (45 мм) Монтаж - Manual (Page 30)

30 Assembly
Slide rail and support rail (continued)
Method 1: Using aluminium rivets
Mounting:
Rivet crimping pliers/rivet crimping clamp
Aluminium rivets
1 Insert rivets in the holes, using rivet crimping pliers or
a rivet crimping clamp. For type of rivet, see table on
previous page.
2 If working space is limited, the rivet crimping clamp
might be easier to use. The two crimping tools per-
form the same task, but the pliers are more efficient
and easier to use.
3 Check that the rivets do not protrude over the surface
of the slide rail.
Check both top and underneath surface of slide rail for
protruding metal.
4 Keep a distance of approximately 30 mm between riv-
ets and idler unit. This is in case the idler unit has to
be removed after conveyor system assembly.
correct
wrong