FlexLink XS (45 мм) Монтаж - Manual (Page 21)

Assembly 21
Conveyor beams (continued)
Assembling conveyor beams
The next step is to connect conveyor beams – straight
sections and bends – to each other. Connect all conveyor
beams according to the instructions below.
Mounting:
Assemble the entire conveyor beam structure in the
same way. If the conveyor beam is too long to mount onto
the support structure in one continuous length, assemble
shorter lengths and connect them to each other once fas-
tened to the support beams.
Straight sections X..CB
Wheel bends X..BH
Horizontal plain bends X..BP
Vertical plain bends X..BV
Allen key 4 mm
Connecting strips with set screws XLCJ
1 Connect two conveyor beam ends by inserting con-
necting strips into the beam T-slots. Use two connect-
ing strips per beam joint.
2 Make sure that the set screws do not prevent the con-
nection strips from sliding into place.
3 Tighten the set screws using an Allen key.