FlexLink XS (45 мм) Монтаж - Manual (Page 39)

Assembly 39
Guide rail system (continued)
Distance pieces (spacers)
XLRD 6/XLRD 6 P
Distance pieces can be used to increase the maximum
track width, and are placed between the guide rail
bracket and the conveyor beam. For the XL conveyor
system, distance piece XLRD 6 P can also be used to
fasten angle plates. (See picture on page 46)
Longer T-bolts must be used if distance pieces are
used with guide rail brackets.
Mounting guide rail brackets (polyamide)
The adjustable guide rails, polyamide, include compo-
nents for construction of a wide variety of guide rail con-
figurations. This includes basic fixed types as well as
high and wide guide rails in various adjustable configura-
tions.
The pictures below show one possible way to assem-
ble guide rail brackets. The examples shown on the fol-
lowing page are assembled in a similar way.
Mounting:
Important:
Do not over-tighten screws!
Socket wrench 13 mm
Allen key 5 mm
T-bolts XLAT 17
Nuts XLAN 8
Washers BRB 8,4×16
1 Fasten a guide rail bracket support to the conveyor
beam using T-bolt, nut and washer.
2 Attach a guide rail clamp to the bracket. Tighten the
screw.
3 Attach the guide rail to the clamp. Tighten the screw.