FlexLink XS (45 мм) Монтаж - Manual (Page 54)

54 Assembly
Final preparations
Plug beam ends
Ensure that end caps (XCBE) have been fitted to all alu-
minium profile ends. The beam profiles should be
deburred before fixing end caps. It may be necessary to
tap the cap into position using a soft-faced hammer.
Anchor feet to the floor
After the assembly of all components it may be neces-
sary to anchor the conveyor support feet to the floor. Use
a type of fastener that is right for the kind of floor where
the conveyor is installed.
Instability of the conveyor during operation may result
in a dangerous operating environment or damage the
conveyor components.
Other preparations
• Adjust the height of the structural beam if necessary.
• Make sure that the installation is stable and that all
screws have been properly tightened.
• Use a plummet and/or water-level to make sure that
the construction is not askew.
• Make sure that all electrical equipment is properly
connected.
• Make sure that the conveyor is running in the correct
direction before starting the conveyor! Never run the
conveyor with tightened slip clutch until you have
ensured that the running direction is correct.
• Tighten the slip clutch to a suitable friction. (Slip clutch
adjustment, see page 66)
• Make sure that the transmission cover is attached to
the drive unit.
• In pallet installations, make sure that all pneumatic
equipment is properly connected.
Remember that conveyor chains should always be
pulled, not pushed, by the drive unit.