FlexLink XS (45 мм) Монтаж - Manual (Page 33)

Assembly 33
Chain
Introduction
When all beams have been assembled and the slide rail
is in place, it is time to assemble and mount the chain on
to the conveyor system.
Joining chain ends
Assemble the chain by inserting the steel pin that comes
with each chain link, into the opposite end of another link.
Do this by using the FlexLink pin insertion tool.
Mounting:
Taking the chain apart:
1 Line the chain tool up with the pin.
2 Depress the trigger until the pin pops out.
3 Depress lever, pull insertion pin out.
4 Pull chain apart.
Pliers
FlexLink chain tool
1 Insert the plastic pivot with the slot facing outward.
2 Insert the steel pin halfway, using a pair of pliers.
Always use new steel pins and plastic pivots when
joining chain ends.
3 Line the FlexLink chain tool up with the pin. Slowly
depress the trigger until the pin seats.
4 Check that the chain is flexible in the joint, and that the
pin does not stick out or go through the other side.
Wrong