FlexLink XS (45 мм) Монтаж - Manual (Page 50)

50 Assembly
Drip trays and drip catchers (continued)
Drip pan for vertical bend X..DV
Mounting:
Box wrench 13 mm
Square nuts
Screws M6S 8×16
Washers BRB 8,4×16
Supporting brackets
Screws M6S 5×6
Washers BRB 5,3×10
1 a) Mount two square nuts on to the drip pan.
If supporting brackets are required (for XH and XK 90°
vertical bends), mount them on to the vertical bends.
Do not tighten the screws fully.
b) If 90° bend, insert the square nuts directly into the
conveyor beam T-slot.
2 Mount the drip pan on to the beam. Do not tighten the
screws fully. Check that the drip pan follows the curve
of the conveyor beam. If not, adjust the position of the
pan until it does.
If used, attach the supporting brackets to the con-
veyor beam T-slots.
3 Tighten the screws.