FlexLink XS (45 мм) Монтаж - Manual (Page 17)

Assembly 17
Beam connectors (continued)
Connecting beams using fastener yokes 1
XCAF
Method 1 – beam end against beam side
Mounting:
Drill
∅ 18,25
Drill fixture XCAD 18
Allen key 5 mm
Hex socket head screws (included) MC6S
Slot nut (included)
1 The fastener yokes shown in the pictures are for
64 mm structural beams.
2 Use an XCAD 18 drill fixture to drill a 18,25 mm hole
through the end of the beam. While drilling in alumin-
ium, be sure to lubricate the drill bit with methylated
spirits.
3 Place a fastener yoke in the hole and insert one 6×30
hex head screw on each side. Insert a slot nut into the
transverse beam.
4 Tighten the screws using an Allen key. (The recom-
mended tightening torque for a lubricated joint is
10 Nm.)