FlexLink XS (45 мм) Монтаж - Manual (Page 58)

58 Assembly
XK pallet system
Installation of pallet locating station
It is very important that the foot is positioned correctly
and anchored to the floor before the locating station is
mounted.
Mounting
1
Tape measure
Plumb bob
Drill
Drill bit
Allen key 5 mm, 6 mm
Spanner 13 mm
Screws M6S 8×20, M6S 8×16
Nuts XCAN 8
Washers BRB 8,4×16
1 Plumb from both sides of the conveyor beam, and
mark the width of the beam on the floor.
2 Mark the centre point between the two marks.
3 From the mark, add 130 mm in each direction to get
the width of the foot. Place the foot in the correct posi-
tion.
4 Drill holes in the floor, for the attachment of the foot.
220
260
110
130
52,5
105