FlexLink XS (45 мм) Монтаж - Manual (Page 18)

18 Assembly
Beam connectors (continued)
Connecting beams using fastener yokes 2
XCAF
Method 2 – beam end against beam end
Mounting:
Allen key 5 mm
Screws MC6S 6×50
Nuts XLAN 6
1 Two fastener yokes are required when mounting
beam end against beam end.
2 Use an XCAD 18 drill fixture to drill a 18,25 mm hole
through the end of the beam. While drilling in alumin-
ium, be sure to lubricate the drill bit with methylated
spirits.
3 Connect the two fastener yokes with one screw and
nut. Place the yokes in the holes of the beams.
4 Connect the yokes on the other side of the beam.
Tighten both screws.