FlexLink XS (45 мм) Монтаж - Manual (Page 34)

34 Assembly
Chain (continued)
Mounting preparations
Procedure:
1 Remove the drive unit transmission cover.
2 Release the slip clutch so that the drive shaft is free to
turn. (Slip clutch adjustment, see page 66)
With the slip clutch loose, make sure that the motor is
turning in the correct direction.
3 Remove the side plate on the drive unit.
4 Before mounting, run a short piece of chain (0,5 m)
through the conveyor to ensure a smooth running sys-
tem. If any obstructions are found, they should be
removed and the checking process repeated.