FlexLink XS (45 мм) Монтаж - Manual (Page 52)

52 Assembly
Front piece
Introduction
The front piece is attached to a vertical or an inclined part
of a conveyor, to prevent products from falling off. It con-
sists of one straight section and one upper and one lower
bend.
The front piece is connected to the conveyor beam by
means of a linkage kit (X..VK) and bend supports (X..
VS).
Front piece assembly
Mounting:
Sliding strip attachment
To prevent direct contact between the products and the
front piece surface, an X..VG 2 plastic sliding strip must
be inserted into the front piece.
Mounting:
Box wrench 13 mm
Front piece X..VF 3/6
Upper bend X..VA 60R460
Lower bend X..VB 60R335
Sliding strip X..VG 2
Linkage kit X..VK 43/93
Locking levers X..VS 43/93
1 Connect straight piece and bends using the connect-
ing strips that are included.
2 Tighten the screws using a box wrench.
1 Slide the strip into the slot on the inner side of the front
piece, before mounting the front piece on to the con-
veyor beam.
2 For safe entry of the products being conveyed, the
protruding end of the sliding strip must be slightly bent
away from the conveyor chain surface to give a “fun-
neling” effect. (Use heater) Fasten the sliding strip to
the front piece using rivets.