FlexLink XS (45 мм) Монтаж - Manual (Page 51)

Assembly 51
Drip trays and drip catchers (continued)
Side-mounted drip catcher
XHDS
The purpose of side-mounted drip catchers is to guide
waste fluid into the drip tray when there is a risk that drips
will fall outside the tray, i.e. the products being conveyed
are wider than the track width itself.
Drip catchers are not available for the XS conveyor
system.
One XHDR 23 drip catcher assembly is required for
each drip catcher end, and one additional bracket
assembly for each meter if the length of the drip catcher
exceeds one meter.
For cutting lengths, see page 47.
Mounting:
Box wrench 13 mm
Drip catcher bracket assembly XHDR 23
T-bolts (included) XLAT 17
Nuts (included) XLAN 8
Washers (included) BRB 8,4×16
1 Fasten the bracket assembly to the beam by tighten-
ing the nut to the right.
2 Fasten the drip catcher to the bracket assembly by
tightening the left nut. Use silicone caulk to seal joints
if necessary.
3 The slot on the bracket assembly also allows angle
plate attachment.