FlexLink XS (45 мм) Монтаж - Manual (Page 24)

24 Assembly
Drive units (continued)
Double drive unit
X..EB 5 HD
C/C 55 (XS), 66 (XL), 86 (XM), 106 (XH) and 106 (XK)
drive units are supplied with four connecting strips. How-
ever, since space is limited, only the two outer connecting
strips can be used for beam attachment. (See mounting
instructions for end drive unit, page 22)
C/C 90–350 (XS), 110–350 (XL), 130–350 (XM), 150–
350 (XH) and 150–350 (XK) drive units are connected to
the beam with four connecting strips. (See mounting
instructions for end drive unit, page 22)
Caution:
Ensure that the shaft is not accessible dur-
ing conveyor operation.
When installing a drive unit,
ensure that the slip clutch is fully
released.
The conveyor chain catenary of
double drive units must be main-
tained during the system lifetime.
When the conveyor chain is visible through the slot
in the side-plate, it must be shortened.
Idler units
Introduction
Idler units are used to guide the conveyor chain into the
return side of the conveyor. Connecting strips are already
attached to the unit.
Idler end unit
X..EJ
Idler bend unit
X..EK
The 90° idler bend can only be used with a return chain
together with the XL conveyor system.