FlexLink XS (45 мм) Монтаж - Manual (Page 46)

46 Assembly
Angle plates
Introduction
X..RP, X..RM
If there is a risk that products will fall off while being con-
veyed, the gap between the actual conveyor and the
guide rails can be filled with angle plates. These are
attached to the beam by means of guide rail brackets and
T-bolts.
Guide rail brackets should be placed across all joints
between angle plates to ensure smooth and durable
joints. 10 mm guide rail is required if guide rail brackets
35×30 are being used to fasten angle plates
Mounting angle plates
Mounting:
Angle plates and guide rail brackets (48×30) for the XL
conveyor system.
Angle plates and guide rail brackets (49×42) for the XM
and XH conveyor systems.
Box wrench 13 mm
T-bolts XLAT 17
Nuts XLAN 8
Washers BRB 8,4×16
Attach guide rail brackets to the conveyor beam without
tightening the nuts. Fasten the angle plate by inserting it
into the slot on the side of the guide rail bracket. Tighten
screws.
XL conveyor system:
In addition to guide rail brackets, distance pieces
XLRD 6 P can be used to fasten angle plates.