FlexLink XS (45 мм) Монтаж - Manual (Page 7)

Assembly 7
Feet
Introduction
Feet are attached to the support beams, and come in a
number of configurations. Follow the mounting instruc-
tions for the type of foot used in your application.
Mounting feet
XCFF:
Mounting
:
Box wrench 13 mm
Connecting strips (included
Hex head screws (included) M6S 8×16
Washers (included) BRB 8,4×16
1 Insert hex head screws and washers into the holes on
the side of the foot.
Use the screws to fasten connecting strips to the inner
side of the foot. Tighten loosely.
2 Slide the connecting strips into the structural beam T-
slots.
3 Raise the beam from the bottom of the foot approxi-
mately 50 mm, to allow for height adjustment later in
the assembly.
4 Tighten the screws using a wrench.