FlexLink XS (45 мм) Монтаж - Manual (Page 38)

38 Assembly
Guide rail system
Introduction
Guide rails are used to guide products being conveyed,
but also to prevent them from falling off the conveyor.
Guide rails are supported by guide rail brackets
attached to the sides of the conveyor beam. Follow the
mounting instructions for the type of bracket used in your
application.
Brackets should be placed approximately 500 to
1000 mm apart depending on type of product and if
accumulation occurs or not. If brackets are spaced at
greater distances than 1000 mm, there is a possibility
that guide rails will become deformed due to excessive
force.
Mounting fixed guide rail brackets (aluminium)
XLRB,XLRA
Mounting:
Note
Do not tighten screws if angle plates are to be
attached to the conveyor. (Angle plates, see
page 46.)
Box wrench 13 mm
Pliers
T-bolts XLAT 17
Nuts XLAN 8
Washers BRB 8,4×16
Spring pins XLAP 28
1 Attach guide rail brackets along the conveyor, using T-
bolts and nuts. The distance between brackets should
be approximately 0,5–1,0 m.
2 Use a pair of pliers to insert a spring pin between the
guide rail bracket and the guide rail.