FlexLink XS (45 мм) Монтаж - Manual (Page 41)

Assembly 41
Guide rail system (continued)
Built-up guide rail brackets
Built-up guide rail brackets are made up from pieces of
small beam with T-slots on three or four sides. The beam
is cut to suitable lengths and connected to form brackets
with the desired height and width.
Special fittings are used to connect the beam pieces
to each other, to the conveyor beam and to the guide rail.
It is possible to use more than one guide rail on each
side.
There are several types of built-up guide rail brackets
(L brackets). Assembly instructions for two different types
are described on the following pages.
Mounting:
Allen key 5 mm
Box wrench 13 mm
Beam XCBB 3Ч24Ч34/44
Inner fitting/corner fitting XMRY 20/XMRW 20
Inner fitting XMRX 20
Guide rail bracket XLRC 20/20A
T-bolts XLAT 17
Nuts XLAN 8
Washers BRB 8,4×16
End caps XCBE 24Ч34/24Ч44
1 a) L bracket Type 1: Use a XMRY 20 inner fitting to
connect two beam pieces. Tighten screws.
b) L bracket Type 2: Use a XMRW 20 corner fitting to
connect two beam pieces that have been cut in a 45°
angle.
2 Attach two XMRX 20 inner fittings to the end of the L-
bracket.
3 Mount the bracket to the conveyor beam using T-bolts,
nuts and washers.