FlexLink XS (45 мм) Монтаж - Manual (Page 62)

62 Assembly
XK pallet system (continued)
Installation of guide rail for XK pallet system
Mounting:
Spanner 13 mm
Slide rail mounting tool 3926757
Set-square
Drill
Drill bit
∅ 4,2 mm
Cutting pliers
Set screw SK6SS 4×20
Screws XLAT 17
Nuts XLAN 8
Washers BRB 8,4×16
1 Cut guide rail to the correct length (length of the cor-
responding conveyor beam ±1,0 mm). Mount a piece
of straight guide rail. Use set-square and mounting
tool for correct positioning. Adjust the end of the rail to
be in line with the conveyor beam joint. Tighten the
screws.
2 Mount guide rail on the opposite side of the track (in
line with the first).
3 If a drip catcher kit is to be used, the inner drip catcher
must be pre-mounted by using a short piece of guide
rail for adjustment.
4 Mount the guide rails for the inner and outer sections
of the bend. Do not tighten the guide rail brackets until
the next straight rail section is positioned and tight-
ened.
5 Mount the next straight guide rail section: check that
the guide rail is aligned with the conveyor beam joint.
Tighten the guide rail bracket fasteners.