FlexLink XS (45 мм) Монтаж - Manual (Page 28)

28 Assembly
Slide rail and support rail (continued)
Mounting slide rail in wheel bends
Before wheel bend:
Mounting:
After wheel bend:
Mounting:
Horizontal plain bends
In plain bends with small radii, the slide rail for the inner
bend should be cut so that it is only 10 mm wide in the
bend. This is to prevent an uneven slide rail surface.
Stretch the rail while mounting.
Note:
Plain bends with small radii should be
avoided, if at all possible. Always consult
FlexLink Systems for design assistance.
Cutting pliers
1 Cut the slide rail end in a 45° angle.
2 The slide rail must be longer than the conveyor beam
itself, and there should be a 10 mm distance between
the slide rail and the wheel of the bend.
Make sure that the end of the slide rail is not bent up
or down.
1 Cut the slide rail in a 45° angle with a short back cut.
The slide rail must be longer than the conveyor beam
itself, and there should be a 2 mm distance between
the slide rail and the wheel of the bend.
2 In the outer bend, make sure that the slide rail is prop-
erly connected to the conveyor beam profile.