FlexLink XS (45 мм) Монтаж - Manual (Page 56)

56 Assembly
Conveyor system XK (continued)
I
6 Use a screwdriver to insert the screws. Cut off the
screw heads using a knife and a hammer. File off pro-
truding edges. The cut should be made away from the
joint, in the direction of travel.
7 Use a clamp to press the slide rail on to the beam
flange where the type N beam begins.
8 Drill one additional hole and insert a screw in the slide
rail at the beginning of the type N beam section.
9 Install the chain as shown in the picture.