MacDon D65 SP DHOM - Manual (Page 105)

OPERATION
6. Attach header to windrower. Refer to windrower
operator’s manual for instructions.
IMPORTANT:
Carrying the tow-bar on the header will affect
the main header float. Refer to your windrower
operator’s manual for adjustment procedures.
7. Place transport wheels into field position. Refer to:
• Moving Front (Left) Wheels into Field Position, page
93
• Moving Rear (Right) Wheels into Field Position,
page 94
Moving Front (Left) Wheels into Field Position
To move the front (left) transport wheels into field position, follow these steps:
DANGER
To avoid bodily injury or death from unexpected start-up or fall of raised machine, always stop engine,
remove key, and engage safety props before going under header for any reason. Refer to the windrower
operator’s manual for instructions regarding the proper use and storage of header safety props.
1. Raise header fully. Engage header safety props.
2. Swivel front wheel assembly (A), so wheels are aligned
with lower frame.
3. Remove pin (B) and pull wheel assembly towards rear
of header. Store pin (B) in hole (C) at top of leg.
4. Pull handle (D) up to release and lower the linkage in
the vertical support.
Figure 4.77: Front (Left) Wheels
169899 93 Revision A