MacDon D65 SP DHOM - Manual (Page 218)

MAINTENANCE AND SERVICING
IMPORTANT:
Ensure tine tube is supported at all times to prevent damage to the tube or other components.
1. Slide new tines and reel arm (A) onto end of tube.
2. Install tine tube bushings. Refer to 6.8.5 Tine Tube
Bushings, page 207 .
3. Attach tines to tine bar with bolts and nuts (B).
Figure 6.164: Tine Tube
Removing Plastic Fingers
WARNING
To avoid bodily injury from fall of raised reel, always
engage reel safety props before going under raised
reel for any reason.
1. Remove screw (A) with a Torx
®
Plus 27 IP
socket wrench.
Figure 6.165: Removing Finger
2. Push finger top clip back toward reel tube and remove
from finger tube.
Figure 6.166: Removing Finger
169899 206 Revision A