MacDon D65 SP DHOM - Manual (Page 178)

MAINTENANCE AND SERVICING
NOTE:
The following two steps are not applicable to the right
side drive.
4. Loosen two bolts (A) on endsheet.
5. Turn adjuster bolt (B) to loosen the two V-belts (C) and
remove them.
Figure 6.79: Knife Drive V-Belts
6. Open the access panel (A) inside the draper opening,
just behind cutterbar. This will give you access to the
knife drive pulley.
7. Remove the knife drive belt.
Figure 6.80: Access Cover
Installing Timed Knife Drive Belt
This procedure is applicable to the knife drive on both left and right sides.
If there are problems with belt alignment. Refer to Adjusting Belt Tracking, page 172 .
1. Route knife drive belt (A) around knife drive pulley (B)
and knife drive box pulley (C).
NOTE:
When installing belt, never pry belt over pulley.
Figure 6.81: Left Side – Right Side Similar
169899 166 Revision A