MacDon D65 SP DHOM - Manual (Page 41)

3 Specifications
| D65 | Attachments
S: standard / O
F
: optional (factory installed) / O
D
: optional (dealer installed) / -: not available
D65
CUTTERBAR
Effective cutting width (distance between crop divider points)
15 ft. header 15.00 ft. (180 in. [4572 mm]) S
20 ft. header 20.00 ft. (240 in. [6096 mm]) S
25 ft. header 25.00 ft. (300 in. [7620 mm]) S
30 ft. header 30.00 ft. (360 in. [9144 mm]) S
35 ft. header 35.00 ft. (420 in. [10,668 mm]) S
40 ft. header 40.00 ft. (480 in. [12192 mm]) S
Cutterbar Lift Range at Guard Tip (Center-Link Fully
Retracted) 49-13/16 in. (1265 mm)
Knife
Single Knife Drive: One hydraulic motor with V-belt to one heavy duty (MD) knife drive box O
F
Double Knife Drive 15–35 ft. (timed): One hydraulic motor with two cogged belts to two heavy
duty MD knife drive boxes O
F
Double Knife Drive 40 ft. (untimed): Two hydraulic motors with banded-belts to two heavy duty
(MD) knife drive boxes O
F
Knife Stroke 3 in. (76 mm) S
20, 25 ft. 1200–1400 S
30 ft. 1200–1400 S
35 ft. 1100–1300 S
Single Knife Speed (strokes per minute)
40 ft. 1050–1200 S
15 ft. 1500–1900 S
20, 25 ft. 1400–1700 S
30 ft. 1200–1600 S
35 ft. 1200–1400 S
Double Knife Speed (strokes per minute)
40 ft. 1100–1400 S
Knife Sections
Over-serrated / Solid / Bolted / 9 serrations per inch O
F
Over-serrated / Solid / Bolted / 14 serrations per inch O
F
Knife Overlap at Center (Double-Knife Headers) 1/8 in. (3 mm) S
Guards and Hold-Downs
169899 29 Revision A