Replacing draper drive roller bearing – MacDon D65 SP DHOM User Manual
Page 204
5.
Remove fasteners (A) and tube connectors (B) at the
draper joint to uncouple the draper.
6.
Pull the draper off the drive roller.
Figure 6.133: Draper Connector
7.
Line up the setscrews with the hole (A) in the guard.
Remove the two setscrews that hold the motor onto
the drive roller.
NOTE:
The setscrews are a 1/4 turn apart.
8.
Remove the four bolts (B) that hold motor to the drive
roller arm.
NOTE:
Plastic shield (C) may require removal to gain access to
the top bolt.
Figure 6.134: Drive Roller
9.
Remove bolt (A) that secures the other end of the drive
roller (B) to the support arm.
10. Remove the drive roller (B).
Figure 6.135: Drive Roller
Replacing Draper Drive Roller Bearing
1.
Remove draper idler roller assembly.
Refer to
Removing Draper Drive Roller, page 191
169899
192
Revision A