MacDon D65 SP DHOM - Manual (Page 206)

MAINTENANCE AND SERVICING
Installing Draper Drive Roller
1. Locate the drive roller (B) between the roller
support arms.
2. Install bolt (A) that holds the drive roller to the arm
closest to the cutterbar.
Torque bolt to 70 ft·lbf
(95 N·m).
3. Grease motor shaft and insert into the end of the
drive roller.
Figure 6.138: Drive Roller
4. Secure motor to the roller support with four bolts (A).
Torque to 20 ft·lbf (27 N·m).
NOTE:
Tighten any loosened bolt and reinstall plastic shield (B),
if removed.
5. Tighten the two set screws through access hole (C).
Figure 6.139: Drive Roller
6. Wrap the draper over the drive roller, and attach ends
of draper with tube connectors (B), screws (A) with
heads facing the center opening, and nuts.
Figure 6.140: Draper Connector
169899 194 Revision A