MacDon D65 SP DHOM - Manual (Page 142)

MAINTENANCE AND SERVICING
Maintenance
Record
Action:  - Check  - Lubricate ▲ - Change

Upper Cross Auger RH
Bearing
250 HOURS OR ANNUALLY 15
 Draper Seal

Upper Cross Auger Center
Support and U-Joint
 Reel Drive U-joint

Transport Axle Pivot
Bushings
500 HOURS OR ANNUALLY 15
 Draper Seal
 Reel Shaft Bearings

Stabilizer/Slow Speed
Transport Wheel Bearings
1000 HOURS OR 3 YEARS 15
▲ Knife Drive Box Lubricant
6.3.2 Break-In Inspection
A break-in inspection includes checking belts, fluids, and a general machine inspection for loose hardware or other
areas of concern. The break-in inspection ensures that all components can operate for an extended period
without requiring service or replacement.
Timing Item Refer To
Check for loose hardware.
Tighten to required torque.
6.2.3 Torque Specifications, page 115
At 5 hours
Check knife drive belts tension.
Periodically check for first 50 hours. Tensioning Timed Knife Drive Belts, page 168
Tensioning Non-Timed Knife Drive Belts, page 163
At 10 hours
Check knife drive box mounting
bolts.
Mounting Bolts, page 153
At 50 hours Change knife drive box lubricant. Changing Oil in Knife Drive Box, page 161
169899 130 Revision A